Fluidampr Crank Pulley for Late 1.8T Engines

Rated 5.0 out of 5
Based on 1 review

FD-551201

Regular price $469.99 Save $-469.99
In Stock

STOP VIBRATIONS AT HIGH RPMS

A stock crank pulley is designed for a stock engine. When an engine is modified, the stock crank pulley does not do its job of keeping vibrations to a minimum. Fluidampr has a solution to that problem! Using a special design, these pullies will eliminate much of the vibration produced by your engine. That will keep your flywheel, trigger wheel, and timing gear on the crank even at high RPM usage!

The Fluidampr pullies have a precisely machined inertia ring inside along with special silicone fluid, that can absorb vibrations through all frequencies. The stock rubber dampened pulley uses rubber for dampening only for the frequency of the stock engine. These Fluidampr pullies are great for any engine setup you may have. They do not require any frequency tuning as a stock pulley would.

You will notice engine vibrations decrease, along with decreased clutch chatter if you have a lightweight flywheel.

These are a must for a modified engine, especially if you are revving higher than stock.

FITMENT

VW - All transverse/longitudinal 20V 1.8T 06A engines Audi - All transverse/longitudinal 20V 1.8T 06A enginesWill not fit early 058 block engines


average rating 5.0 out of 5
Based on 1 review
  • 5 Stars
    1 Review
  • 4 Stars
    0 Reviews
  • 3 Stars
    0 Reviews
  • 2 Stars
    0 Reviews
  • 1 Star
    0 Reviews
100% of reviewers would recommend this product to a friend
1 Review
Reviewed by VWMAN
I recommend this product
Rated 5 out of 5
Review posted

Best mod to reduce flywheel chatter

Could not believe the difference once installing this crank damper on my engine. Going to a single mass flywheel added a ton of in cabin vibration. Once installing the fluidampr it was 90% eliminated.

Loading...
Was this helpful?